form - extrusion

	Extrusion Gear Pump: Questionnaire

	Company
	Department
	Address
	Telephone
	Telefax
	Building / Suite
	City / State
	Zip / Country
	Attention
	E-Mail

	Please submit a quotation for a gear pump for my extrusion application. Your quotation is needed , 20 .

	1. Application	Sheet Film Wire & Cable Blown Film Profile Compounding

	2. Extruder Data

	Extruder mfg.:

	Screw diameter:

	No. of lines:

	L/D ratio:

	Existing capacity:

	Ibs./hr. Existing rpm:

	Existing hp:

	Pressure at end of extruder:	psi

	Discharge pressure at die:	psi

	Continuous screen changer:	yes no

	Static mixer:	yes no

	Have problems with:	Output rate Gauge Temp. Control Specify other

	Processing configuration:	Single Coextrusion Tandem

	Sketch of system provided?	yes no

	Screw design information:

	3. Performance

	Design capacity:	min/max lbs./hr.

	Continuous operation:	yes no

	Expected results:	Eliminate surging Increase capacity Improve dimensional control Increase concentration of regrind Reduce extrudate temperature

	4. Product Data

	Material and composition:

	Operating temperature:

	Resin supplier:

	Product number:

	Specific gravity at melt:

	Melt index:

	Viscosity at operating temp. is:	cps at shear rate of 10 reciprocal seconds

	Does the product contain solids?	yes no

	Size distribution:	% by weight

	Is the product abrasive?	Explain

	Special product characteristics:

	5. Preferred Utilities

	Steam:	psig

	Hot Oil:	temp.

	Electricity:	220 v 440 v other

	6. Comments and Drive Requirements


		back

Extrusion Gear Pump: Questionnaire